Search results

https://www.ebay.co.uk/itm/MBR20100CT-Dual-DIODE-Common-Cathode-SCHOTTKY-20A-10a-Diode-100V-TO-220-x2pcs/300567545997?hash=item45fb38c88d:g:89MAAOSwSpZdovLe...

Show us pics of the bike, the back wheel drop outs and the pedal crank area under neath,

I don't but it is a standard one used as arepkacement in a lot of motor hubs.

Uses a standard 9 pin Julet connector you can use any front motor wheel like the one below. http://www.topbikekit.com/akm100sx-36v250w-ebike-front-driving-hub-motor-36holes-with-2026inch700cc-wheel-rim-p-879.html Spare gears...

I'm one and still have one under the tv.

Probable answer is no as compatibility issues with the display.

Post some pics. The planetary gears are probably like those in Aikema hubs they are stepped for higher motor reduction making pedalling easier unpowered.

The first one is a Switch mode power rectifier, it is a type of mosfet. Second is a Mosfet. Third is a voltage regulator, this regulates incoming higher voltage to a lower voltage probably for the likes of throttle.PAS etc,etc. Whether it is just the fet that has failed , I don't know. All...

12a is a bit weedy, get the same one from PSWpower with 17a output. The 17a one should have a speed sensor wire mine has , if not it is still very easy to wire one in 7 it supports lighting no problem. You need controller and display. Your PAS will wire in ok and throttle 3 wire will wire in...

Only the 2nd Sm one has light and speed sensor output, light is Blue/Black two wire.

54c is approx. 54mm +/- a mm or two, measure the width between the rear stays and front forks.

Looking good enjoy tour new ride, Woosh are very good with CS and issues should you be in need of them.

Test the throttle wiring at the controller, set your meter to 20v dc. Probe the throttle wiring at the connector,poke them in at the rear of the connector if you can't get a good contact shove a pair of needles in first. Measure between Gnd/Black or Yellow and 5v/Red or Brown usually, it should...

I wouldn't worry about the colour buy ss41 hall sensor off ebay.

Long before you can turn the battery off the bike will rear up and be wheelieing away. A brake sensor is instant cut out.

Yes Phase 3 is bad.

Buy a different PAS with smaller dia magnet disc or fit a v12l type all in one sensor.

The hall sensors are imbedded into the motor and receive a signal from a passing magnetic field, when you remove the controller you will see the three phases throttle and pas wiring as well as the 5 wire hall connector. Sometimes this connector doesn't seat properly and can give an intermittent...

Hub or mid drive anyone not fitting a brake cut out for the throttle is asking for trouble should a fault occur.

You need to download the free software programme to your pc as well as buying the programming lead about £20 last time I looked. Have a read. https://electricbike-blog.com/2015/06/26/a-hackers-guide-to-programming-the-bbs02/