Search results

Post or take it to Southend apparently there's a very good electric bike online retailer there.

No quite standard nowadays you have hall sensored/sinewave hub without internal speed sensor, a lot of modern hubs also use a ninth wire for speed sensing. I did mention it in #4. If the GTECH doesn't use a display then it has no need for a hub with a speed hall, if you change controller and...

In #4 you described the Ananda wiring and said three thick wires and five thin wires go to the motor, later I think you said it was actually six. Five or six doesn't matter it is a hall sensored motor/hub. So the Ananda replacement needs to be a sensored/sinewave replacement kit. Now the Lishui...

You will need to look on ebay or to Germany/EU. Have a look at enerprof.de. You will need to look at about £300 and get a decent celled battery that way it can be a hard case frame mount rather then a softpack in a flimsy triangle bag.

Right round two.... The original request was a replacement for the Ananda which you showed pics of and it was a sensored signwave model. This other controller is a Lishui but not the one you received yes ?

You will have to pay duty on all of them, being batteries I don't know how much though plus a handling fee by the courier. It's one thing most buyers don't facto in properly they but a motor but then skimp on the most important item, the power supply.

https://sale.aliexpress.com/__pc/v8Yr8f629D.htm?spm=a2g0o.home.14.6.650c2145Xw907Z

I use both and have been refunded a few times without issue.

If available they tend to be for OEM kits only and as Pete say's are factory fitted.

Yes for the uneducated they are or can be dangerous. Those who have issues tend to be careless or not careful enough about being careful. The extreme cases of fire is down to abusing them beyond their capabilities with high power controller/motor combos for the battery output or self builds...

With ebikes it is the same thing. The sensor uses a hall which needs a magnet disc to act as the signal pulse.

You don't need to modify after market batteries they are only two pin discharge. You need to see how many motor wire there are, there will be three DC phase wires but also you need out find out if there are 5 or 6 hall sensor wires as well. If the motor is sensor less then you need a square...

Yes you can reach the assist limit in any one of the five PAS levels the difference is you can choose the/power current delivered to supply the torque/acceleration, if you don't want to hit the assist limit just pedal a bit more gently. The power levels/five assist levels equals current...

My ones when paralleled discharge pretty much inline to within 0.03v even those of differing capacity. My Swizzbee is hungry being an old brushed motor system(it can often demand 30a constant) has a 23.2ah and 17.5ah which are always used in P they act as one and voltage declines quite...

Even the 2018 evo impulse 2.2 still failed.

2 letters , shall I get my coat ?

Most of the bottle type like you have with the base controller are normally OEM items, they tend to be low power/capacity. Yes the likes of GTECH use handshaking between components so you are tied in to them. After market kits, batteries & controllers etc,etc, don't use those components so you...

The bottom bracket will the standard 34mm English thread used world wide, the current model uses square taper so yours will. Show us a pic to be sure, but yes buy a complete square taper crank set. Hybrid/electric bikes use mtb 104bcd crank sets. About cheapest branded one you will find though...

Derby cycles gmbh are the motor maker another quality German product :rolleyes:.

Try it again. Make sure com port is connected, press the connect button to read parameters correctly. Press the read button only and then make changes, once happy with changes then press only the write button. Once done press the disconnect comp port button. Turn off the battery and wait...