Hi all i have a bafang mid drive motors i have tested the controller and the motor all working but back wheel is not moving battery has been tested as well the display switches on as normal no errors really stuck 8FUN BBSHD BBS03 48V 1000W Bafang Mid Drive checked the back wheel freeze up when pushing backwards if that helps

Remove the chain from the chain wheel and check motor for rotation both ways, the rear wheel unlike a hub wheel won't have any restrictions to prevent it rotating unless there is a mechanical issue with the wheel hub, brakes or cassette.

OK thanks i will try that later on today i will let you know

just took a video i am touching the pedals making it go round terrible sound coming from it here is the link https://www.youtube.com/watch?v=f4aQ17CTIAA any held would be appreciated

Remove the chain to confirm the rear wheel will rotate both ways first without motor power.

Certainly the noise isn't right but one thing at a a time.

Hi sorry for got to say yes it does

does anyone know repair service to fix my BBS03 48V 1000W Bafang Mid Drive near romford Essex

or anyone on the forums who could fix it

That sounds like a hall sensor problem. Check that the connector is in properly. They can get held off by the white silicone sealant they put on them.

does anyone know repair service to fix my BBS03 48V 1000W Bafang Mid Drive near romford Essex

 

The hall sensor connector as vfr has mentioned can be an issue, on my BBS01 I had to remove the silicone from both parts of the connector. You need to gently undo/remove the controller to access the wiring.

 

If still no luck after trying that then Woosh bikes in Southend might help out.

OK thanks i will give it a try

just took it apart removed the sealant on the hall sensor unplugged checked there were no bent pins slid in all the way then put all the wires back in still no luck same issue if you watch the video i posted the issue i think it is the nylon gear i heard this is a common fail as the peddals are not moving at all.this is my bafang can someone confirm i am on the right path thanks

When the nylon hear is stripped, the crank doesn't turn or it's jerky, normally. Another possibility is a faulty MOSFET. You'll have to test halls, MOSFETs and if nothing reveals itself, open the motor.

OK i wil do i will let you know how i get on and thanks for the advice